A96010 Kit (20 second Recording Module with Wires and Speaker Included)
Buy 10, Get 5% Off!
Buy 100, Get 10% Off!
PLEASE NOTE: This module, part # A96010, is actually an A93010. It is virtually identical to the A96010 and it operates the same, but downloadable datasheets are available for each for comparison if necessary. The small size is because the IC is in Chip-on-board form. One button is pushed down to record the message through the on-board electret microphone; A LED turns on during this time. The other button just has to be momentarily pressed to replay the message. A second momentary press during playback will stop the playback. Sampling rate is 4K. The record/play time is determined by the 52K resistor. If you change it to 89K you will get 30 seconds but at a reduced sampling rate.
Operating voltage: 5 to 6 VDC
Standby current: 10 uA.
Operating current: 25mA.
Size: 34 x 23 x 11 mm.
The module comes supplied as you see it in the photo.
This is a kit which includes the following items:
1 x A96010 voice recording module (20 second message)
2 x Connector cable to connect the voice recorder to a speaker and power source. (8 inch each)
1 x 0.5 watt, 50 mm, 8ohm Speaker
(You will need to connect the connector cables to the speaker and a power supply preferably by soldering)
1 x Battery holder that can hold either 4 x AAA or 4 x AA or 4 x C or 4 x D cells. See our battery holders.
This unit will power a 1 watt speaker as is. You do not need to add an external amplifier. However, you can add an external amplifier if you want to drive more than a 1 watt speaker, as long as you follow one of the 2 options below.
HOW TO ADD AN EXTERNAL AMPLIFIER:
METHOD 2: (Alternate Option)
Use this schematic to add a potentiometer when using an additional external amplifier:
When using an external amplifier, you'll need a potentiometer to decrease the high output signal from the A96010 enough to get a clear sound.